Home > Professional Diagnostic Tools
Part Number: Autosim100Brand: Autoditex
Delivery: No charge
Autosim Sensor Simulator and Tester.
Ideal tool for fast sensor testing. Eliminates changing unnecessary parts. Simulates most automotive sensors including O2 , CKP and ABS sensors.
Automotive Sensor Simulator and Tester Revision 2 Latest Version 2 with new features. Latest hardware Two year warranty
Power supply ground and signal ground are galvanically isolated now. DC power supply range extended - 8V to 40V •Added a mode to simulate O2 Zirconia Sensor •Added a mode to simulate O2 Titania Sensor •Added are modes to simulate CKP Inductive and CKP Hall sensors •In both CKP sensor modes you are able to adjust the number of active teeth and the number of missing teeth.AutoSim Automotive sensor simulator and tester is a smart testing device with power-on self-test. It is mainly used to simulate the output signal from automotive sensors: frequency, voltage, and O2 sensor signal.
The Autosim is an easy to use tool with its user-friendly interface and fault tolerance design.
The AutoSim picks up a service problem where the on-board computer's diagnosis ends. Sensors tell the on-board computer something is wrong. AutoSim lets the technician determine if the faulty operation is a faulty sensor, a defect in the wiring or a problem in the computer itself.
The AutoSim is mainly used for wiring tests. This is because the device can simulate the voltages and check the live data readings on the scan tool to confirm the wiring. You can simulate most sensors from ABS to O2 sensors. Eliminates need to replace non-defective sensors, by the time you have changed a couple of un-needed sensors the device has paid for itself.
• Simulates actual working condition of the most automotive sensors;
• Simulates O2 sensor signal; • Checking of basic ECU operation; • Controlling the output signal allows to check the ECU response and operation; • It can drive ECU into "open" or "closed" loop; • Activation of some actuators. Features • Hand-held sensor simulator tester; • Works independently or with any scan tool or oscilloscope• Eliminate unnecessary replacement of non-defective sensors; • Sensor simulation: voltage; frequency; O2 sensor signal; • Trigger output impulse; • Digital LCD display shows actual output of signals; • Matrix LCD screen with backlight; • Output short circuit current protection; • Anti-dirt film keyboard Technical specifications
Voltage simulation range: 0.1V ~ 12VFrequency simulation range: 0.1Hz ~ 10KHzTrigger pulse output: up to 0.15 amperes maximumOutput amplitude: 0.2V to 12V output amplitude can be selected at each modeOutput short circuit current protection: ± 150 mAPower: 12V DC (auto battery typical)Power supply range: 9V DC ~ 40V DC maximum
Power connector: 2.5mm DC PlugQuiescent power current: ≤160mA.Ambient temperature: -5°C ~ +50°CAmbient humidity: 0%RH ~ 85%RHDimensions: 195mm x 100mm x 40mmWeight: 400gStandard Packing List:• AutoSim Main Unit;• AutoSim Main Signal Cable;• Power Cable-2.5mm DC Plug to Crocodile Clips. Warranty: Two years
Auto Electrical Plug Terminal Release Kit£19.99
Full set of 11 terminal release tools,suitable for both round and flat pins.
Stepper Motor Tester£70.00
Use to check proper operation of Idle valves etc that use stepper motors
TEL: 02891 310 043